Know your wheel
Tire and wheel diagrams
The words we use in our instructions, on one page. Find the bead retainer, the drop center and your rim lip before you pick a tool or break a bead.
Wheel feature definitions
The parts of the rim the tool clamps to and works around.
- 1Rim lip (flange)The outer edge of the wheel. The clamp pad grips here and the feet go just under it.
- 2Bead seatThe flat band the tire bead sits on when inflated.
- 3Bead retainerThe raised ridge that holds the bead in place even with no air. The reason ATV tires are so hard to break.
- 4Drop centerThe deepest part of the wheel. Start on the side closest to it.
- 5Wheel faceThe visible outside face of the wheel, usually the shallow side.
Tire feature definitions
The parts of the tire you push on and the parts you need to protect.
- 1TreadThe outside surface that meets the ground.
- 2SidewallThe side of the tire. The ram foot pushes it down, so lube it well.
- 3BeadThe stiff inner edge of the tire that seals against the rim.
- 4Bead bundleThe steel wire inside the bead. Stretch it too far and the tire is done, which is why we use small bites.
Rim lip feature definitions
Three measurements decide which tool and which setup you need.
- 1Lip depth(Outermost rim diameter minus inside tire diameter) divided by 2. Sets how long the feet need to be.
- 2Lip thicknessHow thick the lip is where the clamp pad grips.
- 3Lip widthHow far the lip reaches out from the wheel face.
Rim lip limits at a glance
| Measurement | XB-450i | XB-550i HD |
|---|---|---|
| Lip depth | 0.585" minimum (spacer below that) | 0.585" to 1.500" |
| Lip thickness | [CONFIRM LIMIT] | Under 1.75" |
| Lip width | [CONFIRM LIMIT] | Under 2.70" |